Rust is the number 1 enemy of our power tools but it takes a lot of our time to make sure that it is free from it. Garage and basements is not a good place to store our tools because the humid environment is very harsh for them Here are a few tips to cut off your time in cleaning them .

To obtain additional great tips along with other facts about woodworking plans look into my alternative information sites at woodworking plans

To protect the power tools from the onset of rust, manufacturers makes sure that they are covered with cosmoline to protect them for the harsh elements . Once it is in your shop, this coating must be removed and your cast iron top is no longer protected. Often times we strip our power tools of cosmoline without thinking of the need for ongoing protection .

To protect cast iron surfaces, you must apply a coating that will keep the air and moisture away. The easiest and most effective method is to apply one of the commercially available rust preventative sprays. Two of the most popular brand are the Boeshield T-9 and Empire Top Saver.Both of these sprays are applied directly to the surface and then rubbed down to remove the excess. This step should be repeated periodically to keep a layer of protection on the tool.

The unfortunate reality of tool ownership is that despite every good intention, tools left unprotected will eventually develop rust. And we left it alone for a long time it will definitely damage the whole of it.

This is a jointer without any rust protection. The buildup of sawdust on the cast iron bed encouraged the formation of rust. After only 2 years, this tool was in need of some care.

Steel wool is the most common tool that is used to remove rust formation , but the problem with this abrasive tool is if it can't reach the areas where there are still formation of rust. Fortunately, there are products available that can make this job a lot easier and more effective.

Boeshiled is a rust remover that completes its tasks quickly. If you have larger tools that are impossible for you to soak in rust solution this is the thing for you. Just spray , wait 1 minute and wipe.. If the rust persists, just apply again and use an abrasive such as steel wool or a synthetic abrasive pad to remove the remaining rust.

As soon as you are done with these rust removal step you can go ahead and put some protection on your tool. You may find small rust pits that is caused by the rusts that was formed previously. No method of rust removal can fill in a rust pit once the rust has consumed the metal.

It is advisable that before you use the rust removal you must arm yourself with goggles and gloves to ensure your protection because rust removal are made of acids and these acids removes rust rather quickly.

Protecting your power tools from rust need not to be hard and time consuming, just follow the steps above and you will be able to keep them for a lifetime.